<VV> HEATER BLOWER
jim bannister
jimster1 at earthlink.net
Wed Oct 16 13:27:12 EDT 2019
An open fuse will show voltage across it. An intact fuse will read zero
volts. You want to read from the fuse to ground, either end should show 12
volts.
Jim '66 Turbovert
-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of
WADE LANNING via VirtualVairs
Sent: Wednesday, October 16, 2019 10:24 AM
To: virtualvairs at corvair.org
Subject: Re: <VV> HEATER BLOWER
I have seen fuses show voltage across them with a VOM, but when you put a
load on it, the fuse will not carry the load.
Wade Lanning
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
More information about the VirtualVairs
mailing list