<VV> Spyder dash in Rampside

Hugo Miller hugo at aruncoaches.co.uk
Wed Nov 6 05:55:03 EST 2019


That is what the P.O. did with mine - but aside from the tachometer you 
have the cyl head temp gauge & vacuum gauge to deal with. I am going to 
put an original van dash back in mine.

On 2019-11-06 06:42, FrankDuVal via VirtualVairs wrote:
> Um, no change! The FC uses the same TEMP PRESS lamp for the same
> purpose of reporting oil pressure/head temperature warning.
>
> And the GEN  lamp is also the same.
>
> Frank DuVal
>
> On 10/30/2019 11:15 AM, Brian via VirtualVairs wrote:
>> I am helping a friend rebuild his rampside.  The project is moving 
>> along at a good clip.  He's doing some slight customizing tricks.  One 
>> of them is to install a Spyder dash.  This brings up the issue of what 
>> wiring harness to use.  Obviously we will have to run a wire from the 
>> tachometer back to the coil.  There are some other issues such as what 
>> to do with the circuit that would light the oil pressure/cylinder head 
>> temperature idiot light.  Has anyone done this conversion?  Any 
>> suggestions or information would be very much appreciated.  Thanks in 
>> advance.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________



More information about the VirtualVairs mailing list