<VV> Steering Adjustment

[Bryan Blackwell]

Doc is spot on about tightening the locknut, the screw always wants to move with the nut.  A crowfoot wrench is a handy solution.

--Bryan

> On Mar 20, 2019, at 3:18 PM, roboman91324--- via VirtualVairs <virtualvairs at corvair.org> wrote:
> 
> 4.  Once the adjusting screw is where you want it, you must re-tighten the lock nut.  This may seem straightforward but it deserves some explanation.  If you try to just tighten the nut, the screw will probably move in with it.  This will over tighten the box.  Insert your screwdriver into the screw's slot and hold it in place while tightening the lock nut.  Use the largest screwdriver that will fit in the slot to get leverage.