<VV> Uni-syn

[Harry Yarnell (Verizon)]

First of all, the linkage to each carb must be disconnected from the crosshaft.
With the engine running, and the fast idle cams off, place the Uni-syn on one carb. Dial the thumbwheel till the ball is in the center.
Move the Unisyn to the other carb and adjust the idle speed screw (not mixture) till the ball is in the center.
If the idle is too slow or fast adjust each idle speed screw an equal amount to get to the desired idle.
Fine tune it while  diddling the idle speed screws and moving the uni-syn back and forth, keeping the ball in the middle.
Reconnect the throttle linkage

-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Ralphsebrell via VirtualVairs
Sent: Saturday, June 08, 2019 12:42 PM
To: virtualvairs at corvair.org
Subject: <VV> Uni-syn

I'm trying to use a Uni-Syn Mod A. Passenger primary- the ball goes ALL the way to the top. and stays there. Any idle adjustment
On the driver's primary, the ball stays at the bottom  Any idle adjustment. 
Idle screws bottomed out then backed out 1 1/2 turns. Any comments?\, suggestions appreciated, ThanksRalph69 4sp 140 
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________