<VV> Brake hold down parts

[Harry Yarnell (Verizon)]

Top hold-down washer dimple depends on the length of the pin. In other
words, use what will fit.
The small straight spring is for the parking pawl.
If you're talking about the hold-down springs, I'm not sure it makes a
difference...as long as you can twist on the top hold-down washer and it's
tight.


-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of
David Foster via VirtualVairs
Sent: Sunday, August 11, 2019 9:49 AM
To: 'Virtual Vairs'
Subject: <VV> Brake hold down parts

Need to know where parts go.

Hold down pin top cup.   deeper cup vs. shallow cup ?

Hold down springs.  Straight spring vs. coiled end spring?

 

Picture might help.

 

Thanks 

 

Dave Foster

63 Spyder

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________