<VV> FC Steering Wheel Shaft Size

[Danny Davis]

I put an EM Monza wheel on my 1963 Greenbrier:


Photo attached

 Danny Davis
Graham    WA
 206-643-6718
CORSA Western Director​

On Fri, Jul 13, 2018 at 11:29 AM, Bryan Blackwell via VirtualVairs <
virtualvairs at corvair.org> wrote:

> I'm pretty sure the FC shares the shaft dimensions with '60 - '63 and '67
> - '69 Corvairs (other Chevies from those years too).  I found a post that
> said '67 Camaros used 1/2 - 20.
>
> Be aware that this is a special nut, it's certainly hardened, and it might
> be non-standard in thickness (I've only had ours off once).  I'd use Grade
> 5 or 8 for sure, you might also loctite it on.
>
> --Bryan
>
> > On Jul 13, 2018, at 1:10 PM, Rod Murray via VirtualVairs <
> virtualvairs at corvair.org> wrote:
> >
> > Does anyone know if the steering wheel shaft size is the same for both
> cars and fc’s?  I’ve tried the 7/16-20 size and it doesn’t seem to fit.
> FYI, mines a 64 greenbrier.
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/
> mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
>  _______________________________________________
>