<VV> Differential setup

[Joel McGregor]

Preload, lash and gear contact pattern are critical.  You did replace the two seals on the pinion and all 3 adjuster o-rings, right?
If you are using the same gears the shims are probably correct.
The shop manual had good pictures of the needed contact pattern.

-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Otb Customs via VirtualVairs
Sent: Thursday, January 04, 2018 6:26 PM
To: virtualvairs at corvair.org
Subject: <VV> Differential setup

Any tips or advice on aligning / setting the differential before matong it back with the transmission, the differential manual is a little lacking on the install process but thorough on the breakdown process. It is a 62 rear end with automatic trans I don't think it has positrac, we have the new gears installed and are not sure about the shims and what all needs done before setting the lock