<VV> A couple of 94mm questions
Matt Nall
patiomatt at aol.com
Sat Feb 24 16:01:25 EST 2018
-----Original Message-----
From: Larry Forman
Hi All,
I purchased a "kit" to make a 94mm big bore engine
=======================================================
Larry... 100's have been built... And John BARNES?? did things right!
Don't worry.... Be happy..... they'll be fine.... Splitting problems are with turbo's , super high compression builds...
As far as the Block Studs.... put them in.... if loose... Red LocTite.... then using a tube and washers.... Torque test to 35 ft. lb. No one torques more than 30-32 ft. lb. today..with all the heat cycles this aluminum has seen...
Matt Nall
Charleston, Oregon
http://tinyurl.com/The-Corvair-Patio
http://tinyurl.com/Matts-Tech-Pages
More information about the VirtualVairs
mailing list