<VV> Turn signal mechanism
hugo at aruncoaches.co.uk
hugo at aruncoaches.co.uk
Wed Oct 25 16:50:56 EDT 2017
I thought I had resolved this but it turns out there is more to it -
there should be a little guide for the cable inside the steering hub
that is missing from my car. All sorted now ;)
On 2017-10-25 07:56, Hugo Miller via VirtualVairs wrote:
> I have an issue with that little cable that goes from the mechanism
> in the steering wheel down the mast to the switch. Where the cable
> loops around that little bent piece of wire (the one that acts as a
> bell-crank & changes side-to-side motion to up & down motion), the
> loop at the end of the cable keeps popping off the end of the bell
> crank. Nothing I do makes it stay on there. I just had the steering
> wheel off to repaint it, but that's all. Did I disturb something
> further down perhaps?
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________
More information about the VirtualVairs
mailing list