<VV> Gas guage

[Seth Emerson]

On a late model, at least, that wire is part of the main front to rear body harness. It just peels out in the wrapped harness with enough length for the connector to just push on. There is also a ground wire off the sender that has a screw connector to the lower body.




-----Original Message-----
From: FrankDuVal via VirtualVairs <virtualvairs at corvair.org>
To: virtualvairs <virtualvairs at corvair.org>
Sent: Mon, Dec 18, 2017 6:34 pm
Subject: Re: <VV> Gas guage

Early or Late?

In general, through the tunnel to the body harness, which connects to 
the instrument cluster. No direct connection to the fuse block.

Frank DuVal

On 12/18/2017 9:14 PM, Richard via VirtualVairs wrote:
> Where does the wire from the sending unit go? I think it goes through the tunnel pan to the firewall connector on its way to the fuse panel. Before I put it up on the lift and get rust in my hair, please tell me if I'm correct.  Richard Simoff

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________