<VV> engine stalls

[S M]

Idle circuit(s) in primary carb(s) plugged... 

----- Original Message -----

From: "Michael Kovacs via VirtualVairs" <virtualvairs at corvair.org> 
To: "VV" <virtualvairs at corvair.org>, "DAVID HILL" <dbhill at snet.net>, "brett.aston" <brett.aston at snet.net>, coreyp117 at comcast.net, "NORM LATULLIP" <grantulip at cox.net>, "Bob Peplow" <yenkobluesbrothers at yahoo.com> 
Sent: Saturday, September 24, 2016 6:22:25 AM 
Subject: <VV> engine stalls 

140 4 speed. It was running fine, then after months of inactivity, it starts right up then slowly the RMP below 1500 quickly drops and it stalls. I'm suspecting a vacuum leak. The only work done was to replace the rear main seal and install an electrical oil pressure gauge. Timing is 18, Petronix ignition, balance tube is firmly connected. Vacuum chokes are connected, vacuum advance is connected, carbs are firmly bolted down, vacuum gauge to instrument panel is plugged. Secondary carbs butterflies are totally closed. 




_______________________________________________ 
This message was sent by the VirtualVairs mailing list, all copyrights are the property 
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org 
This list sponsored by the Corvair Society of America, http://www.corvair.org/ 
Post messages to: VirtualVairs at corvair.org 
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
Archives: http://www.vv.corvair.org/archive.htm 
_______________________________________________