<VV> Non Corvair Question

[jvhroberts at aol.com]

Actually, a good sharp tungsten carbide drill should do it. Go slow, lots of lube, etc. 
 

 

John Roberts
 

 

-----Original Message-----
From: Jim Becker via VirtualVairs <virtualvairs at corvair.org>
To: paulsiano <paulsiano at yahoo.com>; Virtual Vairs <virtualvairs at corvair.org>
Sent: Mon, Oct 10, 2016 9:59 pm
Subject: Re: <VV> Non Corvair Question

Given those constraints, take it to a machine shop and have them burn it 
with an EDM.  That is probably your only choice.

Jim Becker

-----Original Message----- 
From: paulsiano--- via VirtualVairs
Sent: Monday, October 10, 2016 7:39 PM
To: Virtual Vairs
Subject:  Non Corvair Question

I would like to put a 1/16th inch hole in a piece of 3/16ths hardened steel. 
Drilling doesn't touch it.  I would like the hole to be neat and don't want 
to use a torch.
Anybody have any suggestions?
Paul Siano

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________