<VV> knurling pinion shaft

[jvhroberts at aol.com]

 Actually, yes!! The best thing to do after knurling is to lightly trim it on a lathe to get the center and the diameter spot on. 

 

John Roberts
 

 

-----Original Message-----
From: Michael R. McCrae via VirtualVairs <virtualvairs at corvair.org>
To: fastvair <fastvair at yahoogroups.com>; virtualvairs <virtualvairs at corvair.org>
Sent: Mon, Nov 21, 2016 6:19 pm
Subject: <VV> knurling pinion shaft

Is it possible to save a GREAT pinion shaft that is loose on the bearing 
by knurling the shaft...?
Mike McCrae
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________