<VV> Front end shimmy Pt 2

[Joel McGregor]

No.  You tighten the nut to zero play with your fingers and then back off until you can install the cotter pin.  Greased bearings have to have a little play in them or they will fail quickly.
Joel McGregor

-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Ralphsebrell via VirtualVairs
Subject: <VV> Front end shimmy Pt 2


So IF it is the bearings, is there a torque value to achieve before the castle nut/cotter pin?
Part 3 soon, I hope
Ralph