<VV> LM Rear Suspension and Diff Questions

[hallgrenn]

....and grease just the bearings, don't pack the hub--too much grease will get past the sesls.
Bob


Sent on the new Sprint Network from my Samsung Galaxy S®4

-------- Original message --------
From: Joel McGregor via VirtualVairs <virtualvairs at corvair.org> 
Date: 10/14/2015  4:45 PM  (GMT-05:00) 
To: virtualvairs at corvair.org 
Subject: Re: <VV> LM Rear Suspension and Diff Questions 

Greasing the won't change the play so measure them before you take them apart and change shims if needed.



Joel McGregor



-------- Original message --------
From: edward szuch via VirtualVairs <virtualvairs at corvair.org>
Date: 10/14/2015 10:23 AM (GMT-06:00)
To: virtualvairs at corvair.org
Subject: LM Rear Suspension and Diff Questions

I'm finally getting some time to address some needed service and possible
adjustments to my '66 Corsa.  It's a 140 with a 4 spd and posi-traction.
It has about 67,000 miles on it.
I removed the power train to re-seal the engine but I also wanted to
re-pack the rear wheel bearings and will be replacing the suspension
bushings.
My questions are:
1) I want to re-pack the rear wheel bearings but I'm concerned about
getting the bearing end play/preload reset correctly after service.  It
looks like there is a spacer and shim(s) used to set this end play.  Do the
factory set-ups hold the correct end play after a bearing service or do I
have to buy a number of shims to re-adjust the end play?  I'm guessing
normal wear may increase the end play and I would have to put in a thinner
shim.

2) I'd also like to tighten up some of the end play in the half shaft yokes
(rear suspension looseness).  The left side has .037" and the right side
has .024".  This seems high but according to Mr R. A. Kirkman's  article in
the Tech Guide Supplement, is probably normal  for a used vehicle.  Looking
at the exploded view in the shop manual, I see that a shim behind the yoke
retaining nut might correct this but I'm not sure if it's even possible.  I
know we all live with this end play but are there any tricks learned over
the years that may improve the condition?

Thanks very much!

Gary Szuch
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________