<VV> Unisyn Question

[Daniel Monasterio González]

Bob,

Those marks are references only and the goal is to have them at same level
in both carburators. If you turn down the round plate on top of the
Unisyn, the bubble will be higher.
I prefer to adjust it at about half the escale. Unisyn is for balancing
only, to read vacuum use a vacuum meter.

Daniel

On 05/10/15 20:49, "Bob via VirtualVairs" <virtualvairs at corvair.org> wrote:

>Hi,
>
>Today, I noticed when using the Unisyn device to balance the primary carbs
>on my 140 that it had 3 marks on the tube, each about ¨ú inch apart.
>Just curious - does anybody know what would be a “good” reading (with
>respect to the marks on the tube) for my 140 at idle?
>
>Right now I have both sides balanced so that the top of the red piston is
>at
>about the top of the first mark. Is that good?
>
>Curious minds….
>
>Thanks,
>
>Bob
>
>66 180 convertible
>
>68 UltraVan
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights
>are the property
>of the writer, please attribute properly. For help,
>mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America,
>http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options:
>http://www.vv.corvair.org/mailman/options/virtualvairs
>Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________
>