<VV> Oil pump tool

[Sethracer at aol.com]

I have at least two of these oil-pump driver  tools on the shelf. Just  pop 
off the gear and the point plate/advance stuff and you are ready to go!  
That is the best use for your old distributor, after you install a NEW one!  
<grin> - Seth Emerson
 
 
In a message dated 10/1/2015 7:26:51 A.M. Pacific Daylight Time,  
virtualvairs at corvair.org writes:


You  guys work way too hard.  What I did was strip down an old distributor  
except for the oil pump shaft rod and housing, slide it into the hole, bolt 
it  down, and then attach my drill to the end of the shaft, just like a 
drill  bit.  Then just pull the trigger and watch the oil flow!! 

Randy (Cap'n) Hook 
'60 700 4dr /'64'110/4spd 
'63 '500' ragtop  110/pg 
'65 Monza 4dr. 84/pg  
_______________________________________________
This message was sent  by the VirtualVairs mailing list, all copyrights are 
the property
of the  writer, please attribute properly. For help,  
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of  America, 
http://www.corvair.org/
Post messages to:  VirtualVairs at corvair.org
Change your options:  http://www.vv.corvair.org/mailman/options/virtualvairs
Archives:  http://www.vv.corvair.org/archive.htm
_______________________________________________