<VV> Installation of new 65 stabilizer inner bushings.

[BBRT]

soap and warm water... If not slippery enough, try some regular lubes.... 
personal or automotive...

Chuck S
----- Original Message ----- 
From: "Jerry Brown via VirtualVairs" <virtualvairs at corvair.org>
To: <virtualvairs at corvair.org>
Sent: Thursday, May 07, 2015 2:44 PM
Subject: <VV> Installation of new 65 stabilizer inner bushings.


> Getting ready to glass bead the 65 stabilizer and have bought a set of 
> bushings from Cal Clark. I've never installed the inner bushings, and 
> sizing up the situation I am going to soap up the bar after the paint 
> dries and put the rubber grommets in hot water to force them past the 
> sharp bends. Does any body have a better method of doing this? If so I'm 
> all ears. I know splitting them and super glue them back, would be quick, 
> but I don't like to do it that way. Jerry Brown
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2013.0.3495 / Virus Database: 4311/9716 - Release Date: 05/07/15
>