<VV> Burnt up diff bearing

[Mike McCrae]

Can't assume anything until it's appraised....if nothing else, it can be 
used on a motor stand for breaking in new engines. Don't throw anything 
away!
My opinion only.....ymmv!

Mike

-----Original Message----- 
From: Smitty via VirtualVairs
Sent: Wednesday, June 24, 2015 8:00 PM
To: virtualvairs at corvair.org
Subject:  Burnt up diff bearing

Mike in most cases the outer race of the pinion end bearing spins in the 
case.  If your new race doesn't fit tight in the case you might as well 
trash it.     Smitty


>
>   1. Re: Early 3-55 standard rear end (Mike McCrae)
>
>
>
> I burnt the pinion bearing up in my rear end and replaced it with a
> complete unit. MY question is, the old rear end is it any good to rebuild, 
> I
> don't want to throw it away if it can be rebuilt.
> _______________________________________________
>
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________