<VV> Early 3-55 standard rear end

[Paul Fox]

I would check the case. If the bearing race spun in the case I  would scrap it. I rebuilt one with out carefully checking the case condition. Guess  what I was doing again the next day?Paul Fox 


     On Tuesday, June 23, 2015 10:10 PM, Mike McCrae via VirtualVairs <virtualvairs at corvair.org> wrote:
   

 It can definitely be rebuilt.....

Mike McCrae

-----Original Message----- 
From: mrmaxum--- via VirtualVairs
Sent: Tuesday, June 23, 2015 6:48 PM
To: virtualvairs at corvair.org
Subject:  Early 3-55 standard rear end

I burnt the pinion bearing up in my rear end and replaced it with a 
complete unit. MY question is, the old rear end is it any good to rebuild, I 
don't want to throw it away if it can be rebuilt.
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________ 

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________