<VV> Rear end, early model

[BobHelt at aol.com]

Hi mrmaxum,
Where is the oil leaking from? Is it from the differential to transmission  
gasket that you replaced? There are other seals to check. I am assuming 
that you  have an EM differentioal unit. Were both surfaces clean when you 
replaced the  gasket? Also I must ask if you used the correct gasket since there 
are certain  holes there to allow gear lube to circulate between the diff 
and trans.
 
Next would be the oil seal inside the differential snout (or shaft).  You 
may not have the correct seal in there since there are two different types  
depending on the year. Also there are two seals (one per axle) where the  
u-joints enter the differential. Leaks there should be very obvious.
 
Let us know just where the oil leak is.
Bob Helt
 
 
In a message dated 7/11/2015 1:06:34 P.M. US Mountain Standard Time,  
virtualvairs at corvair.org writes:

When you  replace a rear end in a early model (rampside) what seal needs to 
be  replaced.  I just replaced mine and put the gasket between the 4 spd.  
transmission and rearend but no seal it is poring oil  now
_______________________________________________
This message was  sent by the VirtualVairs mailing list, all copyrights are 
the property
of  the writer, please attribute properly. For help,  
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of  America, 
http://www.corvair.org/
Post messages to:  VirtualVairs at corvair.org
Change your options:  http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________