<VV> VV: Tech tip (Mark Corbin) - Rear Air Grill MountingAggravation

[Ron Hinz]

I use a little piece of masking tape with the sticky side on the socket. 
Then it always stays with the socket when you pull it off and holds the 
screw better while installing it.
RonH


-----Original Message----- 
From: Kinzelman, Andy via VirtualVairs
Sent: Monday, February 9, 2015 11:38 AM
To: virtualvairs at corvair.org
Subject:  VV: Tech tip (Mark Corbin) - Rear Air Grill MountingAggravation

Guys,
What I have always done is take a small square of paper shop towel; place it 
over the socket; then push the screw head into the socket.  The paper forms 
a decent friction fit into the socket to keep the screw located.  After 
tightening the screw - either the paper stays in the socket (easy to remove) 
or on the screw head (either remove it or wait for it to blow away when you 
are driving your recently fixed car).
Andy K.
Wisconsin
65 Monza daily driver
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________