<VV> Welders

[M Stevens]

Eastwood or even Harbor Freight...as long as it has gas input for bare wire (clean) welding. That's my $.02
Mike


Sent from my putt putt phone...

<div>-------- Original message --------</div><div>From: Bryan Blackwell via VirtualVairs <virtualvairs at corvair.org> </div><div>Date:02/03/2015  5:34 PM  (GMT-08:00) </div><div>To: Virtual Vairs <virtualvairs at corvair.org> </div><div>Cc:  </div><div>Subject: <VV> Welders </div><div>
</div>Hi folks,

I think it's time to get a MIG welder better than the really crappy one I picked up 20 years ago.  Still need to obxerve the budget, has anyone used the $300 job from Eastwood?  I could go $500 but really not any higher.  Not going to weld on a quarter panel, more like for palm sized patches and a late model lower windshield panel.

--Bryan

Bryan Blackwell | Springfield, Va. | bryan at skiblack.com | http://autoxer.skiblack.com/  
  Corvairs: '62 700 Wagon, '64 Greenbrier, '65 Corsa, '66 Corsa
  '69 Road Runner, '99 Neon R/T, '00 Miata SE, '09 Ford F-150
"Why do something if you're not going to obsess about it?"



_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________