<VV> wheel cylinder removal

[Frank DuVal]

Early rear wheel cylinders are held by two bolts (screws). I assume the 
60s are also. To get to these bolt heads, usually you have to loosen the 
four nuts holding the axle bearing/backing plate to the rear A arm. Then 
you can find the two little 3/8" wrench size heads and remove them.

Frank DuVal

On 8/7/2015 3:38 PM, Trey Bosson via VirtualVairs wrote:
> on a 60 rear brake wheel cylinder, do ya just remove hose then remove the anchor pin. to allow the wheel cylinder to come out, I have tried to turn the anchor pin lefty-loosy but it wont turn. doesn't have the anchor pin lock either  trey bosson