<VV> Valve Rattle/Tapping :
Rick Sanford
rsanford at werres.com
Sun Sep 14 11:58:52 EDT 2014
Mark,
He topped off the Oil Filled the Tank with Premium Fuel and took it for a long fun run in the Sunday Morning cool September air. Now it runs great and no noises. He has been Driving his MGA 1600 a lot more than his Corvair this summer.
Rick Sanford
Werres Corp.
800-638-6563x236 office
301-748-4441 cell
rsanford at werres.com
www.werres.com
From: MarK Durham [mailto:62vair at gmail.com]
Sent: Friday, September 12, 2014 11:51 PM
To: Rick Sanford
Cc: virtualvairs at corvair.org; brucemazzie at comcast.net
Subject: Re: <VV> Valve Rattle/Tapping :
Rick, what type of oil is being used? When the mechanic went in and readjusted, had the nuts backed off? And, if its been good all summer and is doing it again, how many are rattling? My car did this and I had three flat getting flatter cam lobes.
If all is good in the cam/lifter department, I might think the rocker arm studs may have worn threads so the nuts cannot lock as well as they should. To know if this is the problem, you would have to verify the cam and or lifters aren't going bad, because wear in the system will show itself in the same fashion as a loosening rocker nut, tapping lifters. .
Mark Durham
Hauser, Idaho
62 Monza coupe Red/Red 4 speed
On Fri, Sep 12, 2014 at 4:21 AM, Rick Sanford via VirtualVairs <virtualvairs at corvair.org<mailto:virtualvairs at corvair.org>> wrote:
A friend has good running `67 Monza Convertible 110hp 4 speed. The engine was built 7 or 8 years a go by a noted and a very experienced Corvair person who had a shop Corvair for a long time. He has had the car for six years, and has spent a lot of money on it, and it has rather low miles. In the past year or so the valves will get out of adjustment and make noise at idle. Last winter he put "new correct self locking nuts" on all the rocker arms and had a noted Corvair Person re-adjust the Valves. Quiet for most of the summer, but now the valves are making noise again. Any Ideas of a cause or cure ?
Rick Sanford
Werres Corp.
800-638-6563x236<tel:800-638-6563x236> office
301-748-4441<tel:301-748-4441> cell
rsanford at werres.com<mailto:rsanford at werres.com>
www.werres.com<http://www.werres.com>
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org<mailto:vv-help at corvair.org>
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org<mailto:VirtualVairs at corvair.org>
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list