<VV> looking for info on adding grease zerks to LM rear wheelbearings

[J. R. Read]

Andy,

It's in Tech Guide 1 under lubrication - page 6.  Lot's of pics.

Later, JR

----- Original Message ----- 
From: "Kinzelman, Andy via VirtualVairs" <virtualvairs at corvair.org>
To: <virtualvairs at corvair.org>
Sent: Friday, October 03, 2014 3:59 PM
Subject: <VV> looking for info on adding grease zerks to LM rear 
wheelbearings


> Guys,
> I am using an 'ultra' rear hub assembly on my car; and considering adding 
> a grease zerk.  I am not convinced it is either prudent or helpful; I have 
> seen many of the discussions about it.
> However, ignoring my reticence - if you have done; or were planning  to do 
> this - where would you put the zerk?
> Thanks,
> Andy K.
> Wisconsin
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com