<VV> Early model engine seal material

[Eric Lucas]

Ken,
 
Me too, 25 years going on 26 in printing. Great material and tough but the color?...uggh! Most press blankets I've seen are some drab greenish color...but I could get tons of that stuff!
 
my .02
 
Eric in Indiana
 
> To: blbrought at gmail.com
> Date: Thu, 20 Nov 2014 16:00:18 -0500
> Subject: Re: <VV> Early model engine seal material
> From: virtualvairs at corvair.org
> 
> Being in and around the printing business most of my life, I've used used printing blankets.  It has a fiber like material on the back and rubber on the top(printing) side.
> Ken
>  
> > Date: Wed, 19 Nov 2014 23:24:28 -0500
> > To: blbrought at gmail.com; virtualvairs at corvair.org
> > Subject: Re: <VV> Early model engine seal material
> > From: virtualvairs at corvair.org
> > 
> > 
> > I just completed this project on my 1962, after having the metal powder coated.  I used the Clarks staples, and used a 1/16" drill bit to enlarge the holes.  The first one took me quite a while, but by the second one, I had mastered the technique and it took me less than a half hour to complete.  I learned that it is best to start at one end, and get that end secured.  Then I went to the other end, and got that end secured.  Putting the staples into the rest of the sheet metal was quick.  I drilled through the original holes, into the fabric, and then out the opposite side, following the path of the original holes.  In my opinion, it was well worth the effort, since it looks like a NOS piece.  I am going to do a write up on this on the Corvair Center forum, when I get a spare moment. 
> > Paul in CT
> > 
> > -----Original Message-----
> > >From: Robert Brought via VirtualVairs <virtualvairs at corvair.org>
> > >Sent: Nov 19, 2014 10:01 PM
> > >To: virtualvairs at corvair.org
> > >Subject: <VV> Early model engine seal material
> > >
> > >I am in the process of preparing early engine sheet metal for powder
> > >coating.  While pulling the original staples from the old rubberized fabric
> > >on the side shields, I seem to recall having seen a slick alternative to
> > >the stock method at one of our Corvair gatherings. If I recall correctly,
> > >someone used Volkswagen (heaven forbid!!) seal material that slipped onto
> > >the edge of the sheet metal and looked clean and neat and did not require
> > >and staples or pop rivets.
> > >
> > >Does anyone recall having seen this or know what material was used??  I am
> > >more interested in clean and simple than pure stock.
> > >
> > >Bob Brought
> > >CorsaSC