<VV> Fan bearing replacement
hallgrenn at aol.com
hallgrenn at aol.com
Mon Mar 24 12:34:45 EDT 2014
Tim, Do you use an oven and if so what temperature?
Thanks,
Bob Hall
-----Original Message-----
From: N2VZD <N2VZD at aol.com>
To: virtualvairs <virtualvairs at corvair.org>
Sent: Mon, Mar 24, 2014 11:28 am
Subject: Re: <VV> Fan bearing replacement
I never use a press on these . or the idler bearing supports , I warm the
housing inside around the shaft area until the bearing about drops out by
itself , then drop a new one in as deep as the old one was while still hot.
some times a SLIGHT tap is needed with a soft hammer, but not usually. same
with idler bearing But I do have to press the bearing into the pulley
before the support.
Regards , Tim Colson
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list