<VV> Need help putting 140 block into PG

[Charlie]

Don't have 140 exhaust -  that's why I want to use the 110 set to test ...

Charlie

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of J. R. Read
Sent: Monday, April 21, 2014 4:58 AM
To: Charlie; 'Rodney Spooner'
Cc: virtualvairs at corvair.org
Subject: Re: <VV> Need help putting 140 block into PG

Move the 140 engine over with dual exhaust intact and still attached to
engine.  Don't use the 110 exhaust.

Oil pan same unless someone put an aftermarket one on.

I'm not sure what sort of performance you get with a manual style 140
attached to a PG, but it will be drivable.

Later, JR

----- Original Message -----
From: "Charlie" <chaz at properproper.com>
To: "'J. R. Read'" <hmlinc at sbcglobal.net>; "'Rodney Spooner'" 
<rodneyspooner at corvairgarage.com>
Cc: <virtualvairs at corvair.org>
Sent: Monday, April 21, 2014 1:32 AM
Subject: RE: <VV> Need help putting 140 block into PG


> Right -  the car has a non-functioning 110 w/ PG and (for now) I want to 
> put
> the 140 in with the PG, just to get behind the wheel of a Corvair after 
> way
> too long, hopefully.
>
> So 2 issues (so far) :
>
> 1 a) 140 has dual exhaust, but it's not required (just to get it running?)
> 1 b) I seem to recall (as you pointed out) that the exhaust ports are 
> bigger
> on a 140's manifolds, so the 110 single setup won't fit, right?
>
> 2) Need to change bell housing (got one)
>
> 3) Need to change out pilot bushing (thanks Matt)
>
> 4) Is oil pan different? I have both so I can compare when the sun comes
> back up...
>
> Thanks!
> Charlie
>
>
> -----Original Message-----
> From: virtualvairs-bounces at corvair.org
> [mailto:virtualvairs-bounces at corvair.org] On Behalf Of J. R. Read
> Sent: Sunday, April 20, 2014 7:04 PM
> To: Charlie; 'Rodney Spooner'
> Cc: virtualvairs at corvair.org
> Subject: Re: <VV> Need help putting 140 block into PG
>
> I'm confused - you want to put a 140 into a PG car or a 4 spd manual car?
> Yep, the bell housings are different.  The exhaust is different between a
> 110 and a 140.  The 140s are different between manual and PG trans.  4
> degree crank retard on PG 140.
>
> So, please help us understand your intentions better.
>
> Thanks
> Later, JR
> ----- Original Message -----
> From: "Charlie" <chaz at properproper.com>
> To: "'Rodney Spooner'" <rodneyspooner at corvairgarage.com>
> Cc: <virtualvairs at corvair.org>
> Sent: Sunday, April 20, 2014 8:11 PM
> Subject: <VV> Need help putting 140 block into PG
>
>
>> Hi Rodney Spooner and VV -
>>
>> Look time out of touch but I want to get back into a Corvair if possible
>> ...
>>
>> I need help putting a 140 block that has a manual bell housing, etc, into
>> my
>> 67 PG Monza.
>>
>> Can you tell me if the 110 stuff that I'm removing with the 110 will port
>> over or do I need more/different parts?
>>
>> I bought a 140 block (reported to run) at GWFBT and I was going to 
>> convert
>> to a Saginaw 4-speed (also bought there) but want to get it running to
>> make
>> sure the engine is good enough to go the Saginaw 4-speed route first.
>>
>> Any ideas?
>>
>> CC to VV also ...
>>
>> Charlie
>>
>> _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights 
>> are
>
>> the property
>> of the writer, please attribute properly. For help,
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America,
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options:
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>> _______________________________________________
>
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
> 


---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________