<VV> bearing identification

[Michael Kovacs]

Thanks to all who responded, yes the 5 looked like a 6. Looks like I still can interpret a 6" steel ruler to measure though. 


From: Daniel Monasterio González <dmonasterio at hotmail.com>
To: Michael Kovacs <kovacsmj at yahoo.com>; VV <virtualvairs at corvair.org>; "fastvair at yahoogroups.com" <fastvair at yahoogroups.com> 
Sent: Wednesday, May 29, 2013 3:03 PM
Subject: Re: <VV> bearing identification


Think you are confusing 6 with 5, as there are no such numbers in the IBI
guide but, LM 603011 + LM 603049 which are Bower, SKF and Timken numbers
to replace GM 7451090. OD = 3.0625", ID = 1.7812", W = 0.7812".

They are for diff. Sides.

Daniel Monasterio


On 29/05/13 13:43, "Michael Kovacs" <kovacsmj at yahoo.com> wrote:

>I have two large roller bearings. I assume for the differential. The
>numbers on the bearing are: KML LM503011 OUTER RACE,
> 
>KML LM503049 INNER
> 
> 
>OD 3.0" race
>ID 1.8"
> 
> 
>Can someone help me verify the application? I probably purchased them for
>my '66.
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights
>are the property
>of the writer, please attribute properly. For help,
>mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America,
>http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options:
>http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>