<VV> Inside Micrometer options
Sethracer at aol.com
Sethracer at aol.com
Wed Mar 20 17:47:27 EDT 2013
Another option - Since barrels are portable - is to take the barrels to a
competent automotive machine shop. The inside measuring tool is called a
"dial bore gauge". They are expensive, and you would not want to buy a kit,
but the design is used just to measure the inside of bores, as on a cylinder
block - or your barrels. It shouldn't take more than a few minutes, and you
can tell them - rightly - that you are considering whether to have them
bored out to an oversize.
Seth Emerson
In a message dated 3/20/2013 1:28:07 P.M. Pacific Daylight Time,
duallycc at gmail.com writes:
Hey All;
I have pulled the barrels off of this 140hp engine and I need to
check both the bore and the pistons. My brother has a set of outside
micrometers, but I need to get an inside micrometer.
More information about the VirtualVairs
mailing list