<VV> Steel noses (throwout bearing shaft).

[Michael McCrae]

Thanks for the info, Tim
I used Larry's noses until he went out of business...probably a similar unit.  You don't appreciate 
them until you or the next guy has  to remove the tranny...
I guess I put 25 or so out there into the community.
 
Mike McCrae
 
> From: N2VZD at aol.com
> Date: Thu, 5 Dec 2013 06:22:15 -0500
> To: virtualvairs at corvair.org
> Subject: Re: <VV> Steel noses (throwout bearing shaft).
> 
> Clark's is a very good unit , I have done a few over the years. You can use 
>  one or two seals , best to use 2.
> C7463 THROW OUT BEARING SHAFT FOR 2 SEAL 
>  
> Regards, Tim Colson
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________