<VV> Used cam with new lifters - break in procedure?
gerg
gergwerks at comcast.net
Mon Aug 12 11:12:53 EDT 2013
I put a single new lifter in recently and used cam lube on the lifter and the lobe. I plan to bring engine up to ~2k rpm like breaking in a new cam for 20 minutes or so. Fingers crossed the whole time.
Thanks,
Greg Blakeney
(318) 680-9224
www.calix.com
On Aug 12, 2013, at 9:44 AM, Bob and Carol <hallgrenn at aol.com> wrote:
> I hope the cam was in good shape and that he used lots of cam lube.
> Bob
>
> Sent from my Samsung Epic™ 4G
>
> "Kinzelman, Andy" <akinzelm at greatnortherncorp.com> wrote:
>
> Guys,
> A club member installed new lifters over a used camshaft. Is there any recommendation for a break in procedure for it?
> Thanks,
> Andy K.
> Wisconsin.
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list