<VV> Single Carburetor

[lonwall@corvairunderground.com]

Without knowing a lot more about your setup it would be hard to be 
specific, but - The type of setup you have is known for poor low end and 
poor response off the line.

Lon
www.corvairunderground.com

On 4/22/2013 11:34 AM, John Ingram wrote:
> I have a 65 110 that I have rigged with a single Rochester 2 barrel
> Carb.  Runs fine, idles fine, the problem is the engine doesn't have
> much low end torque, once I'm moving along it is okay but off the
> line I need to keep the revs up.  I think the drop in vacuum from a
> carb that may be too big is throwing off the timing, the distributer
> vacuum retards the timing when I press on the gas to start out.  Does
> anyone have experience with these single carb applications?  any ideas?
>
> Thank you,
> John I.
>
>   _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>   _______________________________________________
>
>