<VV> Press fit for LM rear bearing assemblies?

[Bryan Blackwell]

Not sure on the first question.  As for the second, yes, other than the backing plates the hubs are identical side to side.  In fact, one "on the road" spare some folks carry is a rear hub with both emergency brake cable holes drilled.

--Bryan

On Apr 8, 2013, at 11:40 AM, Kinzelman, Andy wrote:

> I need to swap out some used rear bearing assemblies; and would like to disassemble them for re-greasing prior to installation.
> Can I use Clark's tool for removing the yoke on an EM axle to remove the U-joint end from the hubs; or is the press fit too great for that?
> Are both hubs common (no reverse threads or anything)?  I know the backing plates are NOT common.
> Thanks,
> Andy K.
> Wisconsin