<VV> Info needed - 65 Steering box shaft length

[Bob and Carol]

Using a tape measure I get 47 3/8" on an early '65 box.

Sent from my Samsung Epic™ 4G

Sethracer at aol.com wrote:

I need someone to measure the overall length of the input shaft of the  
early-1965, non-telescoping, Corvair steering column shaft. When removed  from 
the car, the shaft is bare, the column housing just slides off. I need the  
measurement of the length of the shaft from where it exits the cast iron  
steering box, to the very tip end where the retaining nut starts onto the  
threads. The 1964 is a similar design, but a different length. I have several  
steering boxes here, but none of that design. I have a shaft that was cut 
off of  a box. It is 44 inches long so the length must be more than that.

Seth Emerson
San Jose, CA 
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
_______________________________________________