<VV> Fan belt clearance

[Lonzovair]

John,
Take a late bracket, weld up the two holes, drill out the slot. Piece of cake.  But yes, you either need a 64 bracket, or an early with a/c. Good luck!
Lonzo

John Miller <ssvairnut at yahoo.com> wrote:

>  Just finished reading the current rants. To save time I will just say I solved the horrid red thingy problem...I put a new one on. As far as who makes the best 13 inch tires, the answer is simple, nobody. And since I just successfully changed out a set of o-rings and did a cold adjust...I started the engine with a 5/8 wrench in hand in case I needed some running adjustments(which none were). It's now a perfect world, let's all sing Kumbaya!
>  Now to the heart of todays CRS outbreak. I just aquired a 62 with a 110 motor...It appears I have no clearance for removing the fan belt by the harmonic balancer. I know I need to change out the rear support but to what? a 64? Been a long time since I had this issue. The other being I don't have any other early supports laying around. Inquiring minds need to know.
> 
>John 
>Des Moines
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________