<VV> 4X1 carb setup

[Mark Durham]

Tim, thanks for your take. Did you use progressive linkage or did all
four carbs come at once? Mark Durham

Sent from my Windows Phone
From: N2VZD at aol.com
Sent: 1/11/2012 18:36
To: virtualvairs at corvair.org
Subject: Re: <VV> 4X1 carb setup
I have built a few nice running 4 carb small valve motors over the  years.
recently I have made a couple using flanges from junk heads on 110  heads.
this lets me use 140 fuel lines , stock choke rods , and linkage. only
issue I am having yet is air cleaners on FC's. Using stock flanges lowers the
carbs an inch over the kits (does not turn them)  , but they are still just
a touch too high for bonnets.  I hope to  come up with something  soon for
that problem.
They run great!     running motor on test table  video and pictures are on
the   _www.cnycorvair.com_ (http://www.cnycorvair.com)   web site.
You certainly can feel the better low end.
Regards, Tim Colson


 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________