<VV> Engine assembly questions

[Daniel Monasterio]

I use a dab of gasket sealant on all four corners, up & down joining the bell housing and up & down where join the rear oil distributor.
Can you see the 0 mark on the thin flange, on picture ? It is the timing mark.
Daniel Monasterio


> Date: Wed, 8 Aug 2012 18:02:19 -0400
> From: cityhawk at pobox.com
> To: virtualvairs at corvair.org
> Subject: <VV> Engine assembly questions
> 
> Hi all, I am finally putting together my engine. I have a few questions....
> 1) Is there a sealant I should use between the two crankcase halves?
> 
> 2) How the #$%^ does one find the timing mark on the crankshaft gear? I 
> can't see anything on the gear on account of the flange that obscures it.
> 
> Karl in Boston
> www.chezhawk.com/VairBlog
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________
 		 	   		  
-------------- next part --------------
A non-text attachment was scrubbed...
Name: DSCN3075.JPG
Type: image/jpeg
Size: 1007979 bytes
Desc: not available
Url : http://www.vv.corvair.org/pipermail/virtualvairs/attachments/20120808/edfb6297/attachment.jpe