<VV> Micrometers vs. Plastiguage

[K. Michael Kost]

Matt,

Yes, and it may be even better if done right since it takes into account the 
tolerances of the bearing and block or rod.

Mike Kost



________________________________
From: Matthew Lockwood <matthew_lockwood at hotmail.com>
To: virtualvairs at corvair.org
Sent: Tue, April 3, 2012 11:23:54 AM
Subject: <VV> Micrometers vs. Plastiguage


Wondering if the specs are the same for using a mic vs plastiguage.  So, if the 
green manual calls for a clearance range of .003-.006 on a crank journal (from 
memory, I think thats right), using green plastiguage in lieu of mics should 
suffice, correct?

Thanks,

Matt
                          
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the 
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the CorvairSociety of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
_______________________________________________