<VV> Warning Buzzer Diode
Frank DuVal
corvairduval at cox.net
Mon Oct 31 01:31:43 EDT 2011
Most any diode as used in a power supply will work, not a small signal
diode (1N914 not a good choice).
Minimum specs would be 50 piv (Vr, whatever) and .5 A.
But I would use one of those typical 4000 series, like a 1N4001 to
1N4007, since they are so common. These are rated at 1 amp.
Yes, the diode keeps the buzzer from annoying you when the ignition is
on, but not running, like during starting.
Frank DuVal
On 10/31/2011 1:12 AM, Leland L Garland wrote:
> I'm modifying late model wire harnesses for my 180 engine and Corsa
> dash. What are the specs for the diode for the hi-temp warning buzzer
> in the dash harness? As I understand it, that diode prevents low or no
> oil pressure from setting the buzzer off.
>
> Thanks for any help you can provide.
>
> Leland L Garland
> Phoenix AZ
>
> 65 Monza 180
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
More information about the VirtualVairs
mailing list