<VV> Undercoat Removal Tips
Kurt Guttensohn
rizakoyt at yahoo.com
Fri Oct 28 23:53:11 EDT 2011
I used the same technique on the frame of a 49 Buick. the undercoat came off in chunks. I had a little trouble where oil and grease were sitting below the engine. I had to use the wire wheel on the drill in that area.
________________________________
From: Paul Chapman <corvairjunkie at hotmail.com>
Hi Ray, The best method I've used is an old trick I learned in the Navy.Chip it off. Use something like a Mason's hammer or anything with a wide narrow head with a slight edge on it.doesn't take much effort(don't want to beat a dent into the panel. After you get the knack of it the undercoating comes off in good size chips,leaving a "clean"surface. with final clean up with a putty knife or paint scrapper.Just sweep up the chunks of undercoating.No gooey mess to put up with.
_______________________________________________
More information about the VirtualVairs
mailing list