<VV> resistor wire jumper
BobHelt at aol.com
BobHelt at aol.com
Thu Nov 10 17:15:36 EST 2011
Eric,
This might be true in your Corvair, but the Shop manuals all show a
different set of connections from what you describe. So I wonder about your
description. The SMs show that the resistance wire goes from a terminal in the
main electrical connector in the engine compartment over to the two plug
connector that handles the starter circuits. Not as you describe it.
Regards,
Bob Helt
In a message dated 11/9/2011 12:10:22 P.M. US Mountain Standard Time,
flash at vicsmba.com writes:
At the firewall is the main plug. It is from this plug that
the resistor wire runs up the harness (looking like it is going to
the coil) then does a 180 in the harness and goes back to the
plug.
More information about the VirtualVairs
mailing list