<VV> and Idling
Matt Nall
patiomatt at aol.com
Fri May 20 18:15:54 EDT 2011
Which raises my next question/problem: The RH carb won't maintain a low idle
unless you physically hold down the linkage. It wants to constantly run up above
600-700 rpm. I >don't think it's the idle mixture; it just wants to open the
throttle up. I replaced the bent wire linkage(s) before overhaul with the screw
type linkage bars and have them set like I >think they should be, but to no
avail. The LH one works fine. I put a heavy spring on the connecting bar where
the accelerator rod hooks on, but that just twists that connecting bar >across
the 2 feet or so of travel and the RH one keeps opening up. Any suggestions?
>
=================================================================
Get rid of the heavy spring!! Disconnect the pass. side downlink...
see if it idles fine.... then adjust that rod accordingly.
You don't mention "Balancing Airflow"... I suggest you get someone from the local Corvair Club? to help you...
Matt Nall
Charleston, Oregon
http://mysite.ncnetwork.net/reswr0kp/
More information about the VirtualVairs
mailing list