<VV> 3-speed input shaft
Joel McGregor
joelsplace at earthling.net
Thu Mar 17 21:00:11 EDT 2011
Keep it all together then for a multipurpose tool. I should have said cut it in two pieces but then it would only work if the trans was alone and not on transaxles...
Joel McGregor
________________________________________
From: virtualvairs-bounces at corvair.org [virtualvairs-bounces at corvair.org] On Behalf Of Clark Hartzel [chartzel at comcast.net]
Sent: Thursday, March 17, 2011 8:18 AM
To: Virtual Vairs
Subject: <VV> 3-speed input shaft
If you cut it in half it won't be long enough to check the 12/14 spline in
the trans unless you take off the aluminum bearing cover on the trans.
Clark Hartzel
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list