<VV> without looking

[jvhroberts at aol.com]

I think you're right, the output shaft splines are the same on all 
61-69 manual trannies. I know for a fact (a hard lesson one weekend!) 
that the 61-63 input shaft is smaller, as is the bore through the 
mainshaft.
John Roberts

-----Original Message-----
From: N2VZD at aol.com
To: virtualvairs at corvair.org
Sent: Sat, Mar 12, 2011 9:28 pm
Subject: Re: <VV> without looking


i think early INPUT shaft has smaller splines on tranny end ...but i 
have
been away from stick stuff a while.  i think 63 and 64 had same OUTPUT
shafts though..
i seem to remember someone putting wrong input shaft in a 64 once, 
seemed
ok , until power was put to it.
  just do your homework on those swaps..right down to the pivot pin on  
the
face of the differential. throwout bearing height  etc  etc...  (Clarks
catalog kinda shows what you need to know)
good luck

regards, Tim with all powerglides now.
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights 
are the
property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: 
http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________