<VV> Diesel Oil in Corvair

[Mark Durham]

JR, some older synthetics did cause seal problems, but that was back
in the 90's. I've read reports, on the Amsoil site and several off the
internet, where the full synthetic oil in New York City cabs was run
over 300K miles on gasoline engines without an overhaul, and without
changing the oil. They just changed the bypass filter element every so
often and topped it off then. They also did periodic oil sample tests
to confirm the health of the engine during the test.

When disassembled, the engines had less wear on the internal parts
than a engine using petroleum oil for under 100K miles if I remember
right, and was still clean inside. You could still see the cross hatch
pattern in the cylinder barrels.

So, if you want your Corvair engine to run smoother, seal up the rings
better and run cooler, full synthetic oil in the proper viscosity
range for the engine is the only way to go. Synthetic oils are in a
class of their own.

Here is the traditional disclaimer statement: Synthetic oils will not
fix a tired engine. But if you have good compression and good oil
pressure, it should work for you. If you don't, a higher viscosity
petroleum oil will do you for awhile.
Mark Durham

On Wed, Mar 9, 2011 at 9:37 PM, J R Read <hmlinc at sbcglobal.net> wrote:
> Synthetic!
>
> I've used it - for a couple of years.
>
> Now I wonder - is anyone aware of a DISadvantage?
>
> Later, JR
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>