<VV> My Corvair Stopped. Why?

[Daniel Monasterio]

It looks like a loose or dirty conection on the resistance wire that goes to the (+) terminal on the coil. Dissconect the multiple conector on the left side (close to the 4-6 plug) and clean terminals.

Daniel Monasterio

> From: joelsplace at earthling.net
> To: Vairtec at optonline.net; virtualvairs at corvair.org
> Date: Fri, 15 Jul 2011 23:49:37 -0500
> Subject: Re: <VV> My Corvair Stopped.  Why?
> 
> It sounds like you lost power to the coil in the run position.  When you get power from the starter in the crank position it fires.
> That would mean the resistor wire has no power.  I would check the engine harness to main harness connector after I verified no power at the coil with the key on.
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________