<VV> cam clearance

[shortle]

Is this the only journal that clearance is measured? Or should we be concerned with the clearance in all the journals? By the way,good question Ned.
Timothy Shortle in (hot,dry) Durango Colorado 81301
Waiting for the monsoons to start


-----Original Message-----
>From: Bryan Blackwell <bryan at skiblack.com>
>Sent: Jul 9, 2011 3:05 PM
>To: AeroNed at aol.com
>Cc: virtualvairs at corvair.org
>Subject: Re: <VV> cam clearance
>
>As I recall, maximum is .003".  If you have a case with only .002" on the front journal (the one next to the gear), it's essentially brand new.
>
>--Bryan
>
>On Jul 9, 2011, at 4:49 PM, AeroNed at aol.com wrote:
>
>> I guess I can't read very well because I can't seem to find the clearance  
>> for a LM cam. Any help in finding where that might be located in the shop 
>> manual  would be appreciated.
>> 
>> I have a block with a bit over 2 thousands according to my reading of the  
>> Plasti-gage. Is that OK? And yes "a bit" is engineering units....
>> 
>> Ned
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________