<VV> oil

[Mark Durham]

I agree Dennis, bar chain oil was about the lowest use I could think
of at the time. I run full synthetic in all my equipment. The snow
blower especially likes it. Runs smoother. As I am sure my Corvair
will when I get the rings broken in. Mark Durham

On Thu, Feb 24, 2011 at 6:59 PM, Dennis Pleau <dpleau at wavecable.com> wrote:
> Nah, chain bar oil sticks to the bar much better than any oil not made for
> that purpose.  No one recommends ND oil for engine breakin anymore.  I
> wouldn't even use it in my lawnmower.
>
> dp
>
> dp
>
> -----Original Message-----
> From: virtualvairs-bounces at corvair.org
> [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Mark Durham
> Sent: Thursday, February 24, 2011 5:23 PM
> To: EVERETT WILSON
> Cc: virtualvairs at corvair.org
> Subject: Re: <VV> oil
>
> Really? I didn't look at that. In fact I went to my local Wally's
> world on another errand today and went to check for Accel oil. I did
> find Accel oil, but only in a 30wt non detergent, usefull for breaking
> in engines, but not much anything else except for chain saw blade oil.
> Mark Durham
>
>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>